Complaints & Reviews — Block Key Capital

Technical inspection

I performed a technical inspection in Brisbane. Didzis Jakubovs presses the gasoline at a speed of RPM 4. 5 for almost 2 minutes, where no normal person drives at such a speed, and after gassing catches and records the highest CO% value..... During the test I asked: "What are you doing, it does not run at such a speed and you do not have to keep it that long?" Later, the brakes were also tested 3 times, trying to break the bigger difference between the right and left side. Every nook was tested... Also, he was arrogantly silent throughout the test and did not say a word. The document was rejected, no explanations were given. I don't know if Jakubov is really such a good specialist,that caring about the environment and safety of the machine on the road may already be. For flue gas measurements, I immediately recommend a specific look at the CO value meter before starting the measurement, maybe it immediately shows a value of 3 or more, the filters have not been cleaned or otherwise. Also, run the machine's engine all the time while waiting for your turn and do not stifle. However, I would also recommend trying to document these technical inspections on the phone, because if you are really looking for errors where they are not so specific, then you can immediately prove and ask for measurements on another line for the same payment, on the same day. After a couple of weeks we went to the service, took measurements there, in general showed 0. 02, no more, returned to the SAME technical inspection line, to THE SAME EQUIPMENT, another person performed the test, pressing RPM 2-2. 5, the values ​​suddenly fell from the values ​​set by Jakubuva 4 to 0. 10... And everything is normal